Operating Instructions

T140

The t140 has an on/off switch on the body of the flashlight.
Press down to turn on the light. When you want to change the setting ( High / Medium / Low / Strobe / SOS ), keep pressing on/off switch to move to the desired mode. To zoom pull the head forward. To switch the light off press the on off switch down and hold for 3 seconds.
The on/off switch will start flashing red when the battery level is low. Connect USB charger and allow the battery to charge until the light turns green.

 

T120/ T130 

Click tail-cap to turn on your Tayga flashlight (please make sure your battery is charged first). Click the tail-cap again can turn it off. It will start on the high setting. Lightly clicking the tail-cap can change the mode: High / Medium / Low / Strobe / SOS.

To charge your battery, simply unscrew the tail-cap and remove your rechargeable battery. Place the battery into the battery holder and then connect that with Tayga 2-in-1 charger. Please note that your 2 in 1 chargers male pin can only be inserted half way into battery holder. Do not use any force that may lead to damage.

Now plug your charger into a wall socket or your vehicles cigarette lighter. The charging light will be red while your battery is charging and will turn amber and finally green when fully charged. Do not drain out battery completely before charging. These batteries do not have a memory. Only charge when you notice your light getting a little dim which is after 2 hours on the high setting. Charge times vary but from low to full will take appx. 2 hours.

Also have AAA cartridges provide in your Flashlight Box. Use 3 x AAA batteries if needed during field operations, camping or power outages. Simply unscrew the tail-cap of your flashlight, remove the rechargeable battery and its washer, insert Tayga AAA cartridge with AAA batteries and insert the positive side into the flashlight and re-screw your tail-cap. This AAA cartridge is an added feature for your convenience. Your runtime on AAA batteries will depend on the strength of batteries used but will reduce your overall runtime by 35 – 45 %. And remember the rechargeable 18650 batteries Tayga provide may be charged up to 500 times and is the equivalent of 2000 AAA batteries over the same operational life of appx. 2 years.


T160 / S-160

Remove plastic cover off your 18650 rechargeable Lithium-Ion battery. Your new battery is partially charged. Place your battery into your battery holder. Insert your 2 in 1 AC/DC charger into the battery holder until you hear a “click”. DO NOT force your charger into the battery holder.  Once plugged into your wall or car you will see a red light. This red light will turn green when the charge is complete.

Unscrew the tail-cap and insert your 18650 battery inside your flashlight with the positive side going in. The negative end of the battery will make contact with the spring on the inside of the tail-cap.

Turn on your light press the switch located on the tail-cap. WARNING: DO NOT look directly into the light as this can seriously damage your eyes. Do not point your light into anyone’s eyes unless this is for defensive purposes or against aggressors/predators.

Your flood light can be zoomed by pulling the top end of your light outward. Do not rotate the top of your light. You can half press the tail-cap to lower the intensity.


HL-800
The switch button is located on the back of the light. Press to start on the high setting. Press again for low setting. Press third time for strobe. Charging time is 2-4 hours with DC charger and 1-3 hours with dual charger.


T3000 USER INSTRUCTION

HOW TO START:
REMOVE PLASTIC COVER FROM THE 18650 BATTERIES.
PUT ALL 4 BATTERIES ( + SIDE UP) IN THE BATTERY HOLDER.
GENTLY SCREW THE BATTERY HOLDER BACK ON THE FLASHLIGHT.
DO NOT FORCE AS THIS MAY CAUSE DAMAGE TO THE THREAD.

HOW TO TURN ON/OFF:
PRESS THE SWITCH TO TURN ON THE LIGHT.
LIGHTLY TOUCH THE SWITCH TO CHANGE SETTINGS: HIGH, MEDIUM, LOW, STROBE, SOS. EVERY TOUCH WILL CHANGE THE MODE.
TO TURN OFF THE FLASHLIGHT, KEEP PRESSING THE SWITCH FOR 4-5 SECONDS TILL THE LIGHT IS OFF.

HOW TO CHARGE BATTERIES:
WHEN BATTERIES GO LOW, T3000 DREAMLIGHT WILL START BLINKING TO REMIND THE USER IT IS TIME TO RECHARGE BATTERIES.
PUT BATTERIES INTO THE QUAD CHARGER PROVIDED INSIDE THE CASE.
THE MIDDLE LIGHT WILL TURN ON GREEN WHEN THE BATTERIES ARE CONNECTED TO THE POWER CORRECTLY.
ALL OTHER LIGHTS WILL TURN RED AND TURN OFF WHEN CHARGING IS COMPLETE.
PLEASE DO NOT REMOVE ANY BATTERY FROM THE CHARGER WHILST CHARGING IS IN PROGRESS.


Please enjoy your Tayga Flashlights and email us with any questions you may have at [email protected] or call 1-888-978-1029